Develop ineo+ 6500 Service Manual page 462

Theory of Operation Ver1.0 Sep.2006
6.3.4 Stacker entrance transfer control
The stacker entrance motor (M13) drives the stacker entrance roller, swing belt to transfer the paper to the
stacker, align the trailing edge of the paper, and adjust the staple wait timing.
A. Stacker entrance operation
The downsizing of the device is achieved by adopting the stack method whose incline angle is approximately
70°. The corrugation roller is adopted for the stacker entrance roller [5] to assist the paper exit to the stacker.
After the paper falls to the stacker, the swing belt [6] align the paper with its trailing edge.
To assist in aligning the curled paper with the trailing edge according to the number of sheets stacked and the
paper size, the paper assist solenoid (SD51) [1] pressurizes the paper while the paper assist motor (M51) [3]
drives the paper assist roller [2].
[1] Paper assist solenoid (SD51)
[2] Paper assist roller
[3] Paper assist motor (M51)
[4] Stacker entrance sensor (PS5)
[1]
[2]
[7] [6]
[5] Stacker entrance roller
[6] Swing belt
[7] Stacker empty sensor (PS20)
6. STACKER SECTION
[3]
[4]
[5]
15jmt2c008na
37