Develop ineo+ 6500 Service Manual page 197

6. REVERSE/PAPER EXIT SECTION
(2) Control
1.
After the front side scan is performed [1], the conveyance motor (M302) [2] conveys the original from the
conveyance section, and then the reverse/paper exit motor (M303) conveys it to the reverse path that is set
the paper exit solenoid (SD301) OFF and the original is fed around the reverse roller [3].
2.
When the reverse solenoid (SD302) is turned on [4], the reverse gate sets the conveyance direction toward
the conveyance belt. Then the original starts returning [5] to the conveyance section while sliding under the
conveyance belt.
3.
After the specified time from when the reverse sensor (PS305) has turned ON, M302 and M303 stop rotating
once at the same moment. Then M302 switches to rotate in reverse [6] while M303 rotates forward [7] and
the original is returned further toward the scanning position.
4. After the specified time from PS305 has turned OFF, M303 [8] turns off. However, the belt keeps conveying.
[9]
Timing sensor (PS302)
Forward
Conveyance
motor (M302)
Reve
rse
Reverse sensor (PS305)
For-
ward
Reverse/paper
exit motor
(M303)
Reve
rse
Reverse solenoid (SD302)
[1] Front side scanning
[2] Conveyance to the reverse paper exit sec-
tion (M302)
[3] Conveyance to the reverse paper exit sec-
tion (M303)
[4] Reverse gate setting
[5] Sliding under the conveyance belt
30
[1]
Low
High
High
Low
Low
High
Theory of Operation Ver1.0 Sep.2006
[2] [6]
[3] [4] [5][7] [8] [9]
[6] Reverse conveyance of the belt
[7] Conveyance toward the reverse conveyance
[8] Conveyance completed (M303)
[9] Reverse conveyance by the conveyance
belt
a052t2c022ca