Stacker Entrance Transfer Control - Develop ineo+ 6500 Service Manual

6. STACKER SECTION
B. Stacker entrance transfer control
(1) Stapling mode (the paper size is not A4, B5, or 8
Transmitting the FNS signal from the main body [1], the stacker entrance motor (M13) turns ON and rotates in
high speed.
M13 rotates in low speed [3] when the stacker entrance sensor (PS5) detects the trailing edge of the paper and
then the paper assist roller starts to rotate to transfer the paper to the stacker in low speed. When the paper
assist roller is driven, the paper assist motor (M51) and the paper assist solenoid (SD51) operate to assist the
stacking operation. M13 rotates in high speed and stands by for the subsequent paper after a specified period
of time since it rotates in low speed.
After the last paper of the copy passes, M13 stops when the stapling operation is started [5].
M13 turns ON [6] and rotates in high speed to stand by for the subsequent paper when the paper exit motor
(M8) completes the closing operation.
Stacker entrance sensor (PS5)
Stacker entrance
motor (M13)
Paper assist motor (M51)
Paper assist solenoid (SD51)
Stapler motors (M9 and M14)
Paper exit motor (M8)
[1] FNS start signal turned ON
[2] 1st to 9th paper
[3] Paper transferred to the stacker in low
speed
[4] Paper assist roller in operation
38
High speed
Low speed
[1]
Theory of Operation Ver1.0 Sep.2006
1 / x 11, without the bypassing operation)
2
[2] [4]
[3]
[5] Stapling operation
[6] Closing the paper exit opening
[7] Standing by for the paper of the subsequent
copy
[7]
[5] [6]
15jmt2c009na