Jeep 1987 Wrangler Workshop Manual page 347

ENGINES
4.2 LITER (258 CID) SIX-CYLINDER ENGINE
ENGINE H0L01NG FUTURE
If it is necessary to remove the front engine
mounts and front crossmember to perform
service such as oil pan removal, an engine
holding fixture may be fabricated as illustrated.
1 - 9/16-Inch-12 Nuts
2 - Upper Trunnion
Bearing
3 - Pivot or Sleeve
4 - 2 x 2 x 6-Inch
Hardwood Block
ENGINE REMOVAL
5 - 1 V4-lnch Angle Iron
6 - 1/2-Inch Holes
7 - 1-Inch Hole
8 - 9/16-Inch -
12 Trunnion
41883
The engine is removed separated from the
transmission.
WARNING: The coolant in a recently operated
engine is hot and pressurized. Release the
pressure before removing the radiator draincock
and cap.
Remove the radiator draincock and radiator cap
and drain the coolant.
NOTE: Do not waste reusable coolant. If the
solution is clean, drain it into a clean container
for reuse.
Mark the hinge locations on the hood panel for
alignment reference during installation.
Remove the engine compartment lamp, if
equipped, and remove the hood.
Disconnect the battery cable clamps and
remove the battery.
Disconnect the wire connectors from the
alternator.
Disconnect the ignition coil and distributor wire
connectors.
Disconnect the oil pressure s e n d e r wire
connector.
Remove the vacuum switch assembly bracket
from the cylinder head cover.
Disconnect the front fuel pipe from the fuel
pump and insert a plug to prevent entry of
foreign objects.
Disconnect the engine ground strap.
Remove the right front engine support cushion-
to-bracket nut from the thru-bolt.
S E E
I . S .
N
O
T
E
S
R-113