Pistons And Connecting Rods Assembly Replacement; Pistons And Connecting Rods Assembly Removal - Jeep 1987 Wrangler Workshop Manual

ENGINES
m
2.46 LITER (150 CID) FOUR-CYLINDER ENGINE
m
S E E
I.S.
N
O
T
E
S
PISTONS AND CONNECTING RODS
ASSEMBLY REPLACEMENT
NOTE: The following procedure is used to ser-
vice the piston and connecting rod assemblies
with the engine installed in the vehicle.
PISTONS AND CONNECTING RODS
ASSEMBLY REMOVAL
Remove the cylinder head cover. Refer to
C y l i n d e r H e a d C o v e r R e m o v a l for the
procedure.
84103
Remove the capscrews (1), bridge (2) and pivot
(3) assemblies and rocker arms (4).
CAUTION: Alternately loosen the capscrews,
one turn at a time, to avoid damaging the
bridges.
Remove the push rods (5).
84174
NOTE: Retain the bridge and pivot assemblies,
rocker arms and push rods in the order removed
to facilitate installation at their original locations.
Remove the spark plugs.
Remove the intake manifold, gasket, exhaust
manifold, cylinder head and gasket. Refer to
Cylinder Head Removal for the procedure.
B-88