Vacuum Reservoir; Vehicle Speed Sensor - Jeep 1997 Grand Cherokee Service Manual

VEHICLE SPEED CONTROL CABLE BELLCRANK
8H - 8 VEHICLE SPEED CONTROL SYSTEM
REMOVAL AND INSTALLATION (Continued)
Fig. 6 Cable at Bell Crank—4.0L Engine
Fig. 7 Cable at Bell Crank—5.2L/5.9LV-8 Engines
(6) Remove servo cable from servo. Refer to Speed
Control Servo removal and installation in this group.
INSTALLATION
(1) Install end of cable to speed control servo.
Refer to Speed Control Servo removal and installa-
tion in this group.
(2) Install cable into throttle body mounting
bracket (snaps in).
(3) Install speed control cable connector at throttle
body bellcrank pin (snaps on).
(4) Connect negative battery cable at battery.
CABLE PUSH CONTROL SPEED CONNEC- CABLE TOR
PUSH
RESERVOIR ATTACHING SCREW BATTERY TRAY FWD (2)
POWERTRAIN CONTROL MODULE
For Removal/Installation refer to Powertrain Con-
trol Module in Group 14, Fuel Injection System.

VACUUM RESERVOIR

REMOVAL
(1) Disconnect both battery cables at battery (neg-
ative cable first).
(2) Remove battery holddowns.
(3) Remove battery from battery tray.
(4) Remove 5 bolts securing battery tray.
(5) Pull up battery tray and remove vacuum hose
from reservoir (Fig. 8).
(6) Remove 2 screws holding reservoir to battery
tray.
Fig. 8 Vacuum Reservoir
INSTALLATION
(1) Install vacuum reservoir. Tighten bolts (screws)
to 3 N·m (30 in. lbs.) torque.
(2) Connect vacuum hose at reservoir.
(3) Install battery tray mounting bolts. Tighten to
10 N·m (90 in. lbs.) torque.
(4) Install battery.
(5) Install battery holddown and bolts. Tighten to
10 N·m (90 in. lbs.) torque.
(6) Install battery cable clamp bolts. Tighten to 8.5
N·m (75 in. lbs.) torque.

VEHICLE SPEED SENSOR

For removal/installation, refer to Vehicle Speed
Sensor in Group 14, Fuel System.
VACUUM RESERVOIR VACUUM HOSE
ZG