Jeep 1987 Wrangler Workshop Manual page 205

n
PAINT AND TRIM
ft
n
EXTERIOR DECALS ft
86916
After the decal is removed, spray the panel us-
ing 3M Adhesive Remover, or equivalent, to re-
move any remaining adhesive.
NOTE: Allow the remover to work on the adhe-
sive surface for three to five minutes.
After five minutes, use a squeegee to remove
adhesive residue.
86917
N O T E : If some adhesive is difficult to remove,
spray additional remover on troublesome
spots. Wait approximately two minutes and
s q u e e g e e remaining s p o t s . Repeat as
necessary.
Remove the masking tape and paper.
Wash the entire panel with 3M General Purpose
Adhesive Cleaner, or equivalent. If any spots of
adhesive remain on the panel, hard rubbing
during washdown will remove them.
Installation
Clean the painted surface with 3M General Pur-
pose Adhesive Cleaner, or equivalent. Wipe the
surface with a clean cloth and allow to dry.
N O T E : Freshly painted surfaces must be thor-
oughly dry prior to installing decals. Residual
solvents in fresh paint may cause the decal to
blister.
Position the decal on the panel surface and
mark its position with a grease pencil. Be sure
that a 12.7 mm (1/2-in) excess is allowed to be
wrapped around the door and fender areas, if
necessary.
S E E
I.S.
N
O
T
E
S
l
T-33