Engine Installation - Jeep 1987 Wrangler Workshop Manual

ENGINES
2.46 LITER (150 CID) FOUR-CYLINDER ENGINE
ENGINE INSTALLATION
Lower the engine into the engine compartment.
NOTE: For easier installation, it may be useful to
remove the engine mount cushions from the
engine mount brackets as an aide for alignment
of the engine-to-transmission.
Insert the transmission shaft into the clutch
spline.
Align the flywheel housing with the engine;
install and tighten the flywheel housing lower
bolts finger tight.
Install the engine mount cushions, if removed.
Remove the support stand from beneath the
flywheel housing.
Lower the engine and mount cushions onto the
brackets. Ensure the bolt holes are aligned.
Install the bolts and tighten with the specified
torque.
Remove the engine lifting device.
Raise and support the vehicle.
Attach the exhaust pipe to the manifold. Install
and tighten the nuts.
Install the flywheel housing access cover.
Install the remaining flywheel housing screws.
Install the starter motor and connect the cable.
Lower the vehicle to the floor.
Connect the cooling system hoses and tighten
the clamps.
Connect the hoses to the power steering gear.
Remove the pulley-to-water pump flange
alignment capscrew and install the fan and
spacer or Tempatrol fan assembly.
Tighten the drive belts according to the
specifications listed in the Cooling Systems
section.
Install the fan shroud and radiator.
Connect the throttle valve rod and retainer.
Connect the throttle cable and install the rod.
Install the throttle valve rod spring.
Connect the oxygen (0
2
) sensor wire connector.
Install the vacuum hose and check valve on the
brake booster.
Connect the coolant temperature sensor wire
connector.
Connect the idle speed actuator wire connector.
S E E
I.S.
N
O
T
E
S
•53