Toyota T100 1996 Service Manual page 536

DI−272
N
6. MECHANICAL SYSTEM TESTS
(a) Measure the stall speed.
The object of this test is to check the overall performance of the transmission and engine by measuring
the stall speeds in the D and R positions.
NOTICE:
Do the that at normal operating fluid temperature 50 − 80°C (122 − 176°F)
S
Do not continuously run this test longer than 5 seconds.
S
To ensure safety, conduct this test in a wide, clear, level area which provides good traction.
S
The stall test should always be carried out in pairs. One technician should observe the condi-
S
tions of wheels or wheel stoppers outside the vehicle while the other is doing the test.
(1) Chock the 4 wheels.
(2) Connect an OBD II scan tool or TOYOTA hand−held tester to DLC3.
(3) Fully apply the parking brake.
(4) Keep your left foot pressed firmly on the brake pedal.
(5) Start the engine.
(6) Shift into the D position. Press all the way down on the accelerator pedal with your right foot.
Quickly read the stall speed at this time.
Stall speed:
3RZ−FE: 1,950 ± 150 rpm
5VZ−FE: 2,150 ± 150 rpm
(7) Do the same test in R position.
Stall speed:
3RZ−FE: 1,950 ± 150 rpm
5VZ−FE: 2,150 ± 150 rpm
1996 TOYOTA T100 (RM449U)
DIAGNOSTICS
R
P
Q06793
(g)
Neutral Basic line
Bolt
Groove
AT5115
(h)
− AUTOMATIC TRANSMISSION
(3) Return the No.1 gear shifting rod 2 notches to N
position.
(4) Set the shift lever to N position.
(5) While holding the shift lever lightly toward the R
position side, adjust the No.1 gear shifting rod nut.
(6) Tighten the No.1 gear shifting rod nut.
Torque: 25 N·m (260 kgf·cm, 19 ft·lbf)
(7) Start the engine and make sure that the vehicle
moves forward when shifting the lever from the N to
D position and reverses when shifting it to the R
position.
Inspect and adjust the park/neutral position.
Check that the engine can be started with the shift lever
only in the N or P position, but not in other positions.If it
is not as stated above, carry out the following adjustment
procedure.
(1) Loosen the park/neutral position switch bolt and set
the shift lever to the N position.
(2) Align the groove and neutral basic line.
(3) Hold in position and tighten the bolt.
Torque: 13 N·m (130 kgf·cm, 10 ft·lbf)
Check the idle speed.
Idle speed (In N position and air conditioner OFF):
3RZ−FE: 700 ± 50 rpm
5VZ−FE: 700 ± 50 rpm