Reload - Cisco Catalyst 3560-X Command Reference Manual

reload

reload
Note
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Examples
Catalyst 3750-X and 3560-X Switch Command Reference
2-478
Downloaded from www.Manualslib.com
Use the reload privileged EXEC command to reload the stack member and to put a configuration change
into effect.
reload [LINE | at | cancel | in | slot stack-member-number | standby-cpu]
This command is supported only on Catalyst 3750-X switches.
LINE
at
cancel
in
slot stack-member-number
standby-cpu
Immediately reloads the stack member and puts a configuration change into effect.
Privilege EXEC
Release Modification
12.2(53)SE2 This command was introduced.
If there is more than one switch in the switch stack, and you enter the reload slot stack-member-number
command, you are not prompted to save the configuration.
This example shows how to reload the switch stack:
Switch(config)# reload
System configuration has been modified. Save? [yes/no]: y
Proceed to reload the whole Stack? [confirm] y
This example shows how to reload a specific stack member:
Switch(config)# reload slot 6
Proceed with reload? [confirm] y
This example shows how to reload a single-switch switch stack (there is only one member switch):
Switch(config)# reload slot 3
System configuration has been modified. Save? [yes/no]: y
Proceed to reload the whole Stack? [confirm] y
manuals search engine
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
Specify the reason for the reload.
Specify the time in hh:mm for the reload to occur.
Cancel the pending reload.
Specify a time interval in mmm or hhh:mm for reloads to occur.
Save the changes on the specified stack member and restart it.
Reload the standby route processor (RP).
OL-21522-02