Reload a Module
Note
Power usage is reserved for both supervisor modules regardless of whether one or both supervisor modules
are present.
Use the show environment power command to display power usage information for the switch.
Reload a Module
You can reset a module by using the reload module slot_number command and specifying the module by its
slot number in the chassis.
Caution
Reloading a module disrupts traffic through the module.
Note
To see which slots are filled with modules, use the show inventory command.
Note
These commands report on only software-controlled modules, such as supervisors, system controllers, line
cards, fabric modules, fan trays, and power supplies. Modules that are uncontrolled by software, such as blank
modules installed in empty slots to control airflow are not reported on.
Step 1
Use the configure terminal command to enter the global configuration mode.
Example:
switch# configure terminal
switch(config)#
Step 2
Use the reload module slot_number command to specify the slot number of the module to reset.
Example:
switch(config)# reload module 4
This command will reload module 4. Proceed[y/n]?
reloading module 4 ...
switch(config)#
Rebooting a Switch
You can reboot or reload the switch by using the reload command without any options.
Cisco Nexus 9516 NX-OS Mode Switch Hardware Installation Guide
50
[n] y
Managing the Switch