Copy Running-Config Startup-Config; Provisioning A New Member For A Switch Stack - Cisco Catalyst 3560CX Series Manual

Provisioning a New Member for a Switch Stack

4. copy running-config startup-config

DETAILED STEPS
Command or Action
Step 1 enable
Example:
Device enable
Step 2 switch stack-member-number priority new-priority-number
Example:
Device# switch 3 priority 2
Step 3 show switch stack-member-number
Example:
Device# show switch
Step 4
copy running-config startup-config
Example:
Device# copy running-config startup-config
Provisioning a New Member for a Switch Stack
This optional task is available only from the active switch.
SUMMARY STEPS
1. show switch
2. configure terminal
3. switch stack-member-number provision type
4. end
5. copy running-config startup-config
Managing Switch Stacks
16
Purpose
Enables privileged EXEC mode. Enter your password if
prompted.
Specifies the stack member number and the new priority
for the stack member. The stack member number range is
1 to 8. The priority value range is 1 to 15.
You can display the current priority value by using the show
switch user EXEC command.
The new priority value takes effect immediately but does
not affect the current active stack. The new priority value
helps determine which stack member is elected as the new
active stack when the current active stack or switch stack
resets.
Verify the stack member priority value.
(Optional) Saves your entries in the configuration file.
Managing Switch Stacks