Zone Commit Vsan - Cisco MDS 9000 series Command Reference Manual

zone commit vsan

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
zone commit vsan
To commit zoning changes to a VSAN, use the zone commit vsan command in configuration mode. To
negate the command, use the no form of the command.
Syntax Description
vsan vsan-id
force
Defaults None.
Command Modes Configuration mode.
Command History Release
2.0(1a)
Usage Guidelines
Use the no form of the zone commit vsan command to clear a session lock on a switch where the lock
originated.
Examples The following example commits zoning changes to VSAN 200.
switch# config terminal
Enter configuration commands, one per line.
switch(config)# zone commit vsan 200
Related Commands Command
show zone
Cisco MDS 9000 Family Command Reference
27-4
zone commit vsan vsan-id [force]
no zone commit vsan vsan-id [force]
Specifies the VSAN ID. The range is 1 to 4093.
Forces the commit.
Modification
This command was introduced.
Description
Displays zone information.
End with CNTL/Z.
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 27 Z Commands