Configuring The Time Zone - Cisco Catalyst 9400 System Management Configuration Manual

Administering the Device
Follow these steps to set the system clock:
Procedure
Step 1
Step 2

Configuring the Time Zone

Follow these steps to manually configure the time zone:
Procedure
Step 1
Step 2
Step 3
Command or Action
enable
Example:
Device> enable
Use one of the following:
• clock set hh:mm:ss day month year
• clock set hh:mm:ss month day year
Example:
Device# clock set 13:32:00 23 March 2013
Command or Action
enable
Example:
Device> enable
configure terminal
Example:
Device# configure terminal
clock timezone zone hours-offset
[minutes-offset]
Example:
Device(config)# clock timezone AST -3 30
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
Configuring the Time Zone
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Manually set the system clock using one of
these formats:
• hh:mm:ss Specifies the time in hours
(24-hour format), minutes, and seconds.
The time specified is relative to the
configured time zone.
• day Specifies the day by date in the
month.
• month Specifies the month by name.
• year Specifies the year (no abbreviation).
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Sets the time zone.
Internal time is kept in Coordinated Universal
Time (UTC), so this command is used only for
display purposes and when the time is manually
set.
11