Configuring Ethernet Interfaces
Command
mgmt_show
ping host_ip_address
boot tftp:/file-url ...
copy tftp:/source-file-url
filesystem:/destination-file-
url
1. ARP = Address Resolution Protocol.
Configuring Ethernet Interfaces
•
•
•
•
•
•
Default Ethernet Interface Configuration
Table 8-2
in the table, see
Feature
Allowed VLAN range
Default VLAN (for access ports)
Native VLAN (for 802.1Q trunks) VLAN 1
VLAN trunking
Port enable state
Port description
Speed
Duplex mode
Flow control
EtherChannel (PAgP)
Catalyst 2360 Switch Software Configuration Guide
8-16
Boot Loader Commands (continued)
Default Ethernet Interface Configuration, page 8-16
Configuring SVI Autostate Exclude, page 8-21
shows the Ethernet interface default configuration. For details on the VLAN parameters listed
Chapter 9, "Configuring VLANs."
Default Layer 2 Ethernet Interface Configuration
Description
Displays the statistics for the Ethernet management port.
Sends ICMP ECHO_REQUEST packets to the specified network host.
Loads and boots an executable image from the TFTP server and enters
the command-line interface.
For more details, see the command reference for this release.
Copies a Cisco IOS image from the TFTP server to the specified
location.
For more details, see the command reference for this release.
Default Setting
VLANs 1- 4094.
VLAN 1
Switchport mode dynamic auto (supports DTP)
All ports are enabled.
None defined.
Autonegotiate. (Not supported on the 10-Gigabit interfaces.)
Autonegotiate. (Not supported on the 10-Gigabit interfaces.)
Flow control is set to receive: off. It is always off for sent packets.
Disabled on all Ethernet ports. See
EtherChannels and Link-State Tracking."
Chapter 8
Configuring Interface Characteristics
Chapter 26, "Configuring
OL-19808-01