NETGEAR Managed Switches Software Administration Manual, Release 8.0
but send only RIPv2 formatted frames.
(Netgear Switch) #config
(Netgear Switch) (Config)#interface 1/0/2
(Netgear Switch) (Interface 1/0/2)#ip rip
(Netgear Switch) (Interface 1/0/2)#ip rip receive version both
(Netgear Switch) (Interface 1/0/2)#ip rip send version rip2
(Netgear Switch) (Interface 1/0/2)#exit
(Netgear Switch) (Config)#interface 1/0/3
(Netgear Switch) (Interface 1/0/3)#ip rip
(Netgear Switch) (Interface 1/0/3)#ip rip receive version both
(Netgear Switch) (Interface 1/0/3)#ip rip send version rip2
(Netgear Switch) (Interface 1/0/3)#exit
(Netgear Switch) (Config)#exit
Web Interface: Enabling RIP for Ports 1/0/2 and 1/0/3
1.
From the main menu, select Routing > RIP > Advanced>RIP Configuration. A screen similar to the
following displays.
Figure 7-6
2.
Under the Interface Configuration, enter the following information.
•
Select 1/0/2 in the Interface field.
•
Next to RIP Admin Mode, select the Enable Radio button.
•
Select RIP-2 in the Send Version field.
3.
Click Apply to save the settings.
Routing Information Protocol
v1.0, October 2009
7-7