NETGEAR FSM7328SNA Administration Manual page 52

NETGEAR Managed Switches Software Administration Manual, Release 8.0
Enable protocol vlan group 1 and 2 on the interface.
(Netgear Switch)(Vlan)#exit
(Netgear Switch)#config
(Netgear Switch)(Config)#interface 1/0/11
(Netgear Switch)(Interface 1/0/11)#protocol vlan group 1
(Netgear Switch)(Interface 1/0/11)#protocol vlan group 2
(Netgear Switch)(Interface 1/0/11)#exit
Web Interface: Creating a Protocol-based VLAN
To use the Web interface to configure the managed switch, proceed as follows:
1. Create protocol based VLAN group vlan_ipx.
a. From the main menu, select Switching > VLAN >Advanced > Protocol Based VLAN Group
Configuration. A screen similar to the following displays.
Figure 3-14
Enter the following information in the Protocol Based VLAN Group Configuration.
• In the Group Name field, enter vlan_ipx.
• Select IPX in the Protcol field.
• In the VLAN (1 to 4093) field, enter 4.
b. Click Add
2. Create protocol based VLAN group vlan_ip
3-13
v1.0, October 2009
Virtual LANs