NETGEAR FSM7328SNA Administration Manual page 420

NETGEAR Managed Switches Software Administration Manual, Release 8.0
CLI: Configuring Multiple STP (802.1s)
(Netgear switch) (Config)# spanning-tree
(Netgear switch) (Config)# spanning-tree forceversion 802.1s
(Netgear switch) (Config)# spanning-tree mst instance 1
Create a mst instance 1
(Netgear switch) (Config)# spanning-tree mst priority 1 4096
(Netgear switch) (Config)# spanning-tree mst vlan 1 2
(Netgear switch) (Config)# spanning-tree mst vlan 1 3
Associate the mst instance 1 with the VLAN 2 and 3
(Netgear switch) (Config)# spanning-tree mst instance 2
Create a mst instance 2
(Netgear switch) (Config)# spanning-tree mst priority 2 4096
(Netgear switch) (Config)# spanning-tree mst vlan 2 11
(Netgear switch) (Config)# spanning-tree mst vlan 2 12
Associate the mst instance 2 with the VLAN 11 and 12
(Netgear switch) (Interface 1/0/3)# spanning-tree mst 1 port-priority 128
(Netgear switch) (Interface 1/0/3)# spanning-tree mst 1 cost 0
Web Interface: Configuring Multiple STP (802.1s)
To use the Web interface to configure the managed switch, proceed as follows:
1. Enable 802.1s on the switch.
a. From the main menu, select Switching > STP > STP Configuration.A screen similar to the
following displays.
Figure 25-5
b. Enter the following information in the STP Configuration.
25-5
v1.0, October 2009
Spanning Tree Protocol