NETGEAR FSM7328SNA Administration Manual page 131

NETGEAR Managed Switches Software Administration Manual, Release 8.0
(Netgear Switch) (Interface 2/0/19)#exit
(Netgear Switch) (Config)#exit
(Netgear Switch) #show ip route
Total Number of Routes......................... 2
Network
Address
--------------- --------------- ------------
14.1.1.0 255.255.255.0
14.1.2.0 255.255.255.0
192.168.10.0 255.255.255.0
192.168.20.0 255.255.255.0
192.168.40.0 255.255.255.0
192.168.41.0 255.255.255.0
192.168.42.0 255.255.255.0
Web Interface: Configuring Area 1 as a nssa Area on A1
To use the Web interface to configure OSPF on the switch, proceed as follows:
1. Enable IP routing on the switch.
a. From the main menu, select Routing > IP > IP Configuration. A screen similar to the following
displays.
Figure 8-30
b. Next to the Routing Mode, select the Enable radio button.
c. Click Apply to save the settings.
2. Assign IP address 192.168.10.1 to the port 2/0/11:
a. From the main menu, select Routing > IP > Advanced> IP Interface Configuration. A screen
similar to the following displays.
OSPF
Subnet
Mask Protocol
OSPF Inter
OSPF Inter
Local
Local
OSPF NSSA T2
OSPF NSSA T2
OSPF NSSA T2
v1.0, October 2009
Next Hop Next Hop
Intf IP Address
--------- ---------------
2/0/11 192.168.10.2
2/0/11 192.168.10.2
2/0/11 192.168.10.1
2/0/19 192.168.20.1
2/0/19 192.168.20.2
2/0/19 192.168.20.2
2/0/19 192.168.20.2
8-26