NETGEAR FSM7328SNA Administration Manual page 45

NETGEAR Managed Switches Software Administration Manual, Release 8.0
CLI: Assigning Ports to VLAN3
(Netgear Switch) (Config)#interface range 1/0/2-1/0/4
(Netgear Switch) (conf-if-range-1/0/2-1/0/4)#vlan participation include 3
(Netgear Switch) (conf-if-range-1/0/2-1/0/4)#exit
(Netgear Switch) (Config)#interface 1/0/4
(Netgear Switch) (Interface 1/0/4)#vlan acceptframe all
(Netgear Switch) (Interface 1/0/4)#exit
(Netgear Switch) (Config)#exit
Web Interface: Assigning Ports to VLAN3
To use the Web interface to configure the managed switch, proceed as follows:
1. Assign ports to VLAN 3.
a. From the main menu, select Switching > VLAN >Advanced > VLAN Membership. A screen
similar to the following displays.
Figure 3-6
b. Select 3 in the VLAN ID field
c. Click the Unit 1. The Ports display.
d. Click the gray box under port 2,3 and 4 until T displays. The T specifies that the egress packet is
tagged for the port.
e. Click Apply
2. Specify that untagged frames will be accepted on port 1/0/4.
Virtual LANs
v1.0, October 2009
3-6