NETGEAR Managed Switches Software Administration Manual, Release 8.0
b. Under IP Configuration, make the following selections:
•
Next to Routing Mode, select the Enable radio button.
•
Next to IP Forwarding Mode, select the Enable radio button.
c.
Click Apply to enable IP Routing.
5. Add a static route with IP address 192.268.40.0/24:
a. From the main menu, select Routing > Routing Table > Basic > Route Configuration. A screen
similar to the following displays.
Figure 11-12
b. Under Configure Routes, make the following selection and enter the following information:
•
Select Static in the Route Type field.
•
In the Network Address field, enter 192.168.40.0.
•
In the Subnet Mask field, enter 255.255.255.0.
•
In the Next Hop IP Address field, enter 192.168.200.2.
c.
Click Add.
6.
Create a static route with IP address 192.168.50.0/24:
a.
From the main menu, select Routing > Routing Table > Basic > Route Configuration. A screen
similar to the following displays.
Access Control Lists (ACLs)
v1.0, October 2009
11-15