NETGEAR Managed Switches Software Administration Manual, Release 8.0
1.
From the main menu, select Security > Access > Telnet. A screen similar to the following displays.
Figure 17-5
2. Enter the following information in the Outbound Telnet.
3. Next to the Admin Mode, select the Enable radio button.
4.
Click Apply
CLI: session-limit and session-timeout
(Netgear Switch Routing) (Line)#session-limit ?
<0-5>
allowed.
(Netgear Switch Routing) (Line)#session-limit 5
(Netgear Switch Routing) (Line)#session-timeout ?
<1-160>
(Netgear Switch Routing) (Line)#session-timeout 15
Web Interface: Configuring the Session Timeout
To use the Web interface to configure the outbound telnet session in the managed switch, proceed as follows:
Tools
Configure the maximum number of outbound telnet sessions
Enter time in minutes.
v1.0, October 2009
17-13