NETGEAR FSM7328SNA Administration Manual page 433

NETGEAR Managed Switches Software Administration Manual, Release 8.0
(Netgear Switch) #show ipv6 interface 1/0/1
IPv6 is enabled
IPv6 Prefix is ................................ FE80::21E:2AFF:FED9:249B/128
Routing Mode................................... Enabled
Administrative Mode............................ Enabled
IPv6 Routing Operational Mode.................. Enabled
Bandwidth...................................... 1000000
Interface Maximum Transmit Unit................ 1500
Router Duplicate Address Detection Transmits... 1
Router Advertisement NS Interval............... 0
Router Advertisement Lifetime.................. 1800
Router Advertisement Reachable Time............ 0
Router Advertisement Interval.................. 600
Router Advertisement Managed Config Flag....... Disabled
Router Advertisement Other Config Flag......... Disabled
Router Advertisement Suppress Flag............. Disabled
IPv6 Destination Unreachables.................. Enabled
Prefix 2000::2/64
Preferred Lifetime............................. 604800
Valid Lifetime................................. 2592000
Onlink Flag.................................... Enabled
Autonomous Flag................................ Enabled
Web Interface: Creating an IPv6 Routing Interface
To use the Web interface to create an IPv6 routing interface, proceed as follows:
1. Enable IPv6 forwarding and unicast routing on the switch.
a. From the main menu, select Routing > IPv6 >Basic>Global Configuration. A screen similar to the
following displays.
Figure 27-1
b. Next to the IPv6 Unicast Routing, select the Enable Radio button.
IPv6 Interface Configuration
v1.0, October 2009
2000::2/64 [TENT]
kbps
27-2