NETGEAR FSM7328SNA Administration Manual page 353

NETGEAR Managed Switches Software Administration Manual, Release 8.0
The example is shown as CLI commands and as a Web interface procedure.
CLI: Specifying the Source (Mirrored) Ports and Destination (Probe)
(Netgear Switch)#config
(Netgear Switch)(Config)#monitor session 1 mode
Enable mirror
(Netgear Switch)(Config)#monitor session 1 source interface 1/0/2
Specify the source interface.
(Netgear Switch)(Config)#monitor session 1 destination interface 1/0/3
Specify the destination interface.
(Netgear Switch)(Config)#exit
(Netgear Switch)#show monitor session 1
Session ID Admin Mode
-------------
1
Web Interface: Specifying the Source (Mirrored) Ports and Destination
(Probe)
To use the Web interface to show monitor session, proceed as follows:
1. From the main menu, select Monitoring > Mirroring>Port Mirroring. A screen similar to the following
displays.
Figure 17-2
2. Under Multiple Port Mirroring, scroll down to interface 1/0/2 and select the checkbox for
1/0/2. The value 1/0/2 now appears in the Interface field at the top.
3. Enter the following information in the Status Table.
• In the Destination Port field, enter 1/0/3.
• Select Enable in the Session Mode field.
4. Click Apply.
Tools
Probe Port
---------------
Enable
v1.0, October 2009
Mirrored Port
------------- ----------------
1/0/3 1/0/2
17-7