NETGEAR FSM7328SNA Administration Manual page 358

NETGEAR Managed Switches Software Administration Manual, Release 8.0
CLI: show telnet
(Netgear Switch Routing)#show telnet
Outbound Telnet Login Timeout (minutes)........ 5
Maximum Number of Outbound Telnet Sessions..... 5
Allow New Outbound Telnet Sessions............. Yes
CLI: transport output telnet
(Netgear Switch Routing) (Config)#lineconfig ?
<cr>
(Netgear Switch Routing) (Config)#lineconfig
(Netgear Switch Routing) (Line)#transport ?
input
output
(Netgear Switch Routing) (Line)#transport output ?
telnet
(Netgear Switch Routing) (Line)#transport output telnet ?
<cr>
(Netgear Switch Routing) (Line)#transport output telnet
(Netgear Switch Routing) (Line)#
Web Interface: Configuring Telnet
To use the Web interface to configure the Telnet in the managed switch, proceed as follows:
17-12
Press Enter to execute the command.
Displays the protocols to use to connect to a
specific line of the router.
Displays the protocols to use for outgoing
connections from a line.
Allow or disallow new telnet sessions.
Press Enter to execute the command.
v1.0, October 2009
Tools