NETGEAR FSM7328SNA Administration Manual page 232

NETGEAR Managed Switches Software Administration Manual, Release 8.0
The <bw> value is a percentage that ranges from 0 to 100 in increments of 5. The default bandwidth value is
0, meaning no upper limit is enforced, which allows the interface to transmit up to its maximum line rate.
The bw value is independent of any per-queue maximum bandwidth value(s) in effect for the interface and
should be considered as a second-level transmission rate control mechanism that regulates the output of the
entire interface regardless of which queues originate the outbound traffic.
CLI: Configuring traffic-shape
(Netgear Switch) (Config)#traffic-shape?
<bw>
(Netgear Switch) (Config)#traffic-shape 70?
<cr>
(Netgear Switch) (Config)#traffic-shape 70
(Netgear Switch) (Config)#
Web Interface: Configuring Traffic-shape
To use the Web interface to configure traffic-shape, proceed as follows:
1. Set the shaping bandwidth percentage to 70%.
a. From the main menu, select QoS > Advanced >CoS Interface Configuration. A screen similar to
the following displays.
Figure 12-7
12-10
Enter the shaping bandwidth percentage from 0 to 100
in increments of 5.
Press Enter to execute the command.
v1.0, October 2009
Class of Service (CoS) Queuing