NETGEAR Managed Switches Software Administration Manual, Release 8.0
Enable captive portal instance 1 on port 1/0/1.
(Netgear Switch) (Config-CP 1)#interface 1/0/1
Web Interface: Enabling Captive Portal
To use the Web interface to configure the Captive Portal, proceed as follows:
1.
Enable Captive Portal on the switch.
a.
From the main menu, select Security > Control >Captive Portal> CP Global Configuration. A
screen similar to the following displays.
Figure 32-1
b. Next to the Admin Mode, Select the Enable radio button.
c.
Click Apply.
2.
Enable Captive Portal instance 1 on the switch.
Captive Portal
v1.0, October 2009
32-3