NETGEAR Managed Switches Software Administration Manual, Release 8.0
(Netgear Switch) (Interface 1/0/15)#exit
(Netgear Switch) (Config)#exit
(Netgear Switch) #show ip route
Total Number of Routes......................... 6
Network
Address
--------------- --------------- ------------
0.0.0.0
0.0.0.0
192.168.20.0
255.255.255.0
192.168.30.0
255.255.255.0
192.168.40.0
255.255.255.0
192.168.41.0
255.255.255.0
192.168.42.0
255.255.255.0
Web Interface: Configuring Area 1 as a nssa Area on A2
To use the Web interface to configure OSPF on the switch, proceed as follows:
1.
Enable IP routing on the switch:
a.
From the main menu, select Routing > IP > IP Configuration. A screen similar to the following
displays.
Figure 8-37
b. Next to the Routing Mode, select the Enable radio button.
c.
Click Apply to save the settings.
2. Assign IP address 192.168.30.1 to the port 1/0/11:
a.
From the main menu, select Routing > IP > Advanced> IP Interface Configuration. A screen
similar to the following displays.
8-31
Subnet
Mask
Protocol
OSPF Inter
Local
Local
RIP
RIP
RIP
v1.0, October 2009
Next Hop
Next Hop
Intf
IP Address
---------
---------------
1/0/15
192.168.20.1
1/0/15
192.168.20.2
1/0/11
192.168.30.1
1/0/11
192.168.30.2
1/0/11
192.168.30.2
1/0/11
192.168.30.2
OSPF