NETGEAR FSM7328SNA Administration Manual page 115

NETGEAR Managed Switches Software Administration Manual, Release 8.0
(Netgear Switch) (Config)#interface 1/0/4
(Netgear Switch) (Interface 1/0/4)#ip ospf
(Netgear Switch) (Interface 1/0/4)#ip ospf areaid 0.0.0.2
(Netgear Switch) (Interface 1/0/4)#ip ospf priority 255
(Netgear Switch) (Interface 1/0/4)#ip ospf cost 64
(Netgear Switch) (Interface 1/0/4)#exit
(Netgear Switch) (Config)#exit
Web Interface: Configuring OSPF on a Border Router
To use the Web interface to configure OSPF on the switch, proceed as follows:
1. Enable IP routing on the switch:
a. From the main menu, select Routing > IP > IP Configuration. A screen similar to the following
displays.
Figure 8-8
b. Next to the Routing Mode, select the Enable radio button.
c. Click Apply to save the settings.
2. Assign IP address 192.150.2.2 to the port 1/0/2:
a. From the main menu, select Routing > IP > Advanced> IP Interface Configuration. A screen
similar to the following displays.
OSPF
v1.0, October 2009
8-10