NETGEAR Managed Switches Software Administration Manual, Release 8.0
Enable OSPFv3 on the interface 1/0/1, and set the OSPF network mode to broadcast.
(Netgear Switch) (Interface 1/0/1)#ipv6 ospf
(Netgear Switch) (Interface 1/0/1)#ipv6 ospf network broadcast
(Netgear Switch) #show ipv6 ospf neighbor
Router ID
Priority
----------
--------
2.2.2.2
1
On A2, Enable IPv6 unitcast routing on the switch.
(Netgear Switch) (Config)#ipv6 unicast-routing
Enable OSPFv3 and assign 2.2.2.2 to router ID.
(Netgear Switch) (Config)#ipv6 router ospf
(Netgear Switch) (Config-rtr)#enable
(Netgear Switch) (Config-rtr)#router-id 2.2.2.2
(Netgear Switch) (Config-rtr)#exit
Enable routing mode on the interface 1/0/13 and assign 2000::2 to IPv6 address.
(Netgear Switch) (Config)#interface 1/0/13
(Netgear Switch) (Interface 1/0/13)#routing
(Netgear Switch) (Interface 1/0/13)#ipv6 address 2000::2/64
(Netgear Switch) (Interface 1/0/13)#ipv6 enable
Enable OSPFv3 on the interface 1/0/13, and set the OSPF network mode to broadcast.
(Netgear Switch) (Interface 1/0/13)#ipv6 ospf
(Netgear Switch) (Interface 1/0/13)#ipv6 ospf network broadcast
(Netgear Switch) #show ipv6 ospf neighbor
Router ID Priority
--------
--------
1.1.1.1
1
Web Interface: Confguring
To use the Web interface to configure OSPF on the switch A1, proceed as follows:
1.
Enable IPv6 unicast routing on the switch:
OSPF
Intf ID
Interface
-------
---------
13
1/0/1
IntfID
Interface
------
---------
1
1/0/13
v1.0, October 2009
State
--------------
Full/BACKUP-DR
State
DeadTime
---------
----
Full/ DR
34
DeadTime
-------
34
8-42