NETGEAR FSM7328SNA Administration Manual page 20

7000 series managed switch administration guide for software version 8.0
Table of Contents

Advertisement

NETGEAR Managed Switches Software Administration Manual, Release 8.0
Table 1-1. Quick Start Commands (continued)
Command
users passwd
<username>
copy system:running-
config nvram:startup-
config
logout
show network
network parms <ipaddr>
<netmask> [gateway]
1-7
Mode
Global
Allows the user to set passwords or change passwords
Config
needed to login.
A prompt appears after the command is entered requesting
the users old password. In the absence of an old password
leave the area blank.
User password should not be more than eight characters in
length.
Privileged
Saves passwords and all other changes to the device.
EXEC
If you do not save the configuration, all changes are lost when
you power down or reset the networking device. In a stacking
environment, the running configuration is saved in all units of
the stack.
User EXEC
Logs the user out of the networking device.
Privileged
EXEC
User EXEC Displays the following network configuration information:
• IP Address - IP Address of the interface (default: 0.0.0.0)
• Subnet Mask - IP Subnet Mask for the interface (default:
0.0.0.0)
• Default Gateway - The default Gateway for this interface
(default: 0.0.0.0)
• IPv6 Administrative Mode - Indicates whether IPv6 is
enabled.
• IPv6 Prefix is - The prefix/prefix length of the IPv6 address.
• Burned in MAC Address - The Burned in MAC Address used
for in-band connectivity
• Locally Administered MAC Address - Can be configured to
allow a locally administered MAC address
• MAC Address Type - Specifies which MAC address should
be used for in-band connectivity
• Network Configurations Protocol Current - Indicates which
network protocol is being used (default: none)
• Configured IPv6 Protocol - Indicates which network protocol
is being used (default: none) for IPv6.
• Management VLAN Id - Specifies VLAN id
Privileged
Sets the IP address, subnet mask and gateway of the router.
EXEC
The IP address and the gateway must be on the same subnet.
IP address range is from 0.0.0.0 to 255.255.255.255.
v1.0, October 2009
Description
Getting Started

Advertisement

Table of Contents
loading

Table of Contents