NETGEAR FSM7328SNA Administration Manual page 164

NETGEAR Managed Switches Software Administration Manual, Release 8.0
Define the second rule for ACL 101 to set similar conditions for UDP traffic as for TCP traffic.
(Netgear Switch) (Config)#access-list 101 permit udp 192.168.77.0 0.0.0.255
192.178.77.0 0.0.0.255
Apply the rule to inbound traffic on port 1/0/2. Only traffic matching the criteria will be accepted.
(Netgear Switch) (Config)#interface 1/0/2
(Netgear Switch) (Interface 1/0/2)#ip access-group 101 in
(Netgear Switch) (Interface 1/0/2)#exit
(Netgear Switch) (Config)#exit
Web Interface: Setting up an IP ACL with Two Rules
To use the Web interface to configure IP ACL on a port on the switch, proceed as follows:
1. Create IP ACL 101 on the switch:
a. From the main menu, select Security > ACL > IP ACL. A screen similar to the following displays.
Figure 11-2
b. In the IP ACL ID field, enter 101.
c. Click Add to create ACL 101.
2. Create a new rule associated with the ACL 101.
a. From the main menu, select Security > ACL >IP ACL> IP Extended Rules. A screen similar to the
11-4
v1.0, October 2009
Access Control Lists (ACLs)