NETGEAR Managed Switches Software Administration Manual, Release 8.0
b. Under PIM-DM Interface Configuration, scroll down to interface 1/0/1 and select the checkbox for
1/0/1. Then select 1/0/9 and 1/0/13.
c.
In the PIM-DM Interface Configuration, select Enable in the Admin Mode field.
d. Click Apply to save the settings.
On Switch B:
To use the Web interface to config PIM-DM, proceed as follows:
1.
Enable IP routing on the switch.
a.
From the main menu, select Routing >IP >Basic >IP configuration. A screen similar to the
following displays.
Figure 28-12
b. Next to the Routing Mode, select the Enable radio button.
c.
Click Apply.
2.
Configure 1/0/10 as a routing port and assign IP address to it.
a.
From the main menu, select Routing > IP >Advanced > IP Interface Configuration. A screen
similar to the following displays.
PIM
v1.0, October 2009
28-12