NETGEAR FSM7328SNA Administration Manual page 127

NETGEAR Managed Switches Software Administration Manual, Release 8.0
Web Interface: Configuring Area 1 as a Stub Area on A2
To use the Web interface to configure OSPF on the switch, proceed as follows:
1. Enable IP routing on the switch.
a. From the main menu, select Routing > IP > IP Configuration. A screen similar to the following
displays.
Figure 8-24
b. Next to the Routing Mode, select the Enable radio button.
c. Click Apply to save the settings.
2. Assign IP address 192.168.10.1 to the port 1/0/15.
a. From the main menu, select Routing > IP > Advanced> IP Interface Configuration. A screen
similar to the following displays.
Figure 8-25
b. Under IP Interface Configuration, scroll down to interface 1/0/15 and select the checkbox for that
interface. Now 1/0/15 appears in the Interface field at the top.
c. Enter the following information in the IP Interface Configuration:
• In the IP Address field, enter 192.168.20.2.
• In the Network Mask field, enter 255.255.255.0.
OSPF
v1.0, October 2009
8-22