NETGEAR FSM7328SNA Administration Manual page 143

NETGEAR Managed Switches Software Administration Manual, Release 8.0
b. Enter the following information in the VLAN Routing Wizard.
• In the Vlan ID field, enter 10.
• In the IP Address field, enter 192.150.3.1.
• In the Network Mask field, enter 255.255.255.0.
c. Click Unit 1. The ports display:
Click the gray box under port 2 once until T displays.
The T specifies that the egress packet is tagged for the port.
d. Click Apply to save the VLAN that includes ports 2.
2. Configure a VLAN and include ports 1/0/3 in the VLAN:
a. From the main menu, select Routing > VLAN > VLAN Routing Wizard. A screen similar to the
following displays.
Figure 8-46
b. Enter the following information in the VLAN Routing Wizard.
• In the Vlan ID field, enter 20.
• In the IP Address field, enter 192.150.4.1.
• In the Network Mask field, enter 255.255.255.0.
c. Click Unit 1. The ports display:
Click the gray box under port 3 once until T displays.
The T specifies that the egress packet is tagged for the port.
d. Click Apply to save the VLAN that includes ports 3.
3. Enable OSPF on the switch.
a. From the main menu, select Routing > OSPF > Basic>OSPF Configuration. A screen similar to the
following displays.
OSPF
v1.0, October 2009
8-38