NETGEAR FSM7328SNA Administration Manual page 79

NETGEAR Managed Switches Software Administration Manual, Release 8.0
CLI: Enabling Routing for Ports on the Switch
(Netgear Switch) #config
(Netgear Switch) (Config)#interface 1/0/2
(Netgear Switch) (Interface 1/0/2)#routing
(Netgear Switch) (Interface 1/0/2)#ip address 192.150.2.1 255.255.255.0
(Netgear Switch) (Interface 1/0/2)#exit
(Netgear Switch) (Config)#interface 1/0/3
(Netgear Switch) (Interface 1/0/3)#routing
(Netgear Switch) (Interface 1/0/3)#ip address 192.150.3.1 255.255.255.0
(Netgear Switch) (Interface 1/0/3)#exit
(Netgear Switch) (Config)#interface 1/0/5
(Netgear Switch) (Interface 1/0/5)#routing
(Netgear Switch) (Interface 1/0/5)#ip address 192.150.5.1 255.255.255.0
(Netgear Switch) (Interface 1/0/5)#exit
(Netgear Switch) (Config)#exit
Web Interface: Enabling Routing for Ports on the Switch
To use the Web interface to configure the managed switch, proceed as follows:
1. Assign IP address 192.150.2.1/24 to the interface 1/0/2.
a. From the main menu, select Routing > Advanced >IP Interface Configuration. A screen similar to
the following displays.
Figure 5-3
b. Under IP Interface Configuration, scroll down to interface 1/0/2 and select the checkbox for that
interface. Now 1/0/2 appears in the Interface field at the top.
c. Under the IP Interface Configuration, enter the following information.
Port Routing
v1.0, October 2009
5-4