NETGEAR FSM7328SNA Administration Manual page 343

NETGEAR Managed Switches Software Administration Manual, Release 8.0
Web Interface: Configuring SNTP
To use the Web interface to configure SNTP, proceed as follows:
1. Configure SNTP server
a. From the main menu, select System > Management>Time>SNTP Server Configuration. A screen
similar to the following displays.
Figure 16-1
b. Enter the following information in the SNTP Server Configuration.
• Select IPV4 in the Server Type field.
• In the Address field, enter 208.14.208.19
• In the Port field, enter 123
• In the Priority field, enter 1
• In the Version field, enter 4
c. Click Add.
2. Configure SNTP global configuration
a. From the main menu, select System > Management>Time>SNTP Global Configuration. A screen
similar to the following displays.
Simple Network Time Protocol (SNTP)
v1.0, October 2009
16-4