NETGEAR Managed Switches Software Administration Manual, Release 8.0
(Netgear Switch) (Config)#ex
(Netgear Switch) #show ip ospf neighbor interface all
Router ID
IP Address
----------------
4.4.4.4
2.2.2.2
(Netgear Switch) #show ip route
Total Number of Routes......................... 4
Network
Address
--------------- --------------- ------------
14.1.1.0
255.255.255.0
14.1.2.0
255.255.255.0
255.255.255.0
Local
192.168.20.0
255.255.255.0
Web Interface: Configuring Area 1 as a Stub Area on A1
To use the Web interface to configure the switch, proceed as follows:
1.
Enable IP routing on the switch:
a.
From the main menu, select Routing > IP > IP Configuration. A screen similar to the following
displays.
Figure 8-17
b. Next to the Routing Mode, select the Enable radio button.
c.
Click Apply to save the settings.
2. Assign IP address 192.168.10.1 to the port 2/0/11:
a.
From the main menu, select Routing > IP > Advanced> IP Interface Configuration. A screen
similar to the following displays.
8-17
Neighbor Interface
-----------
-------------------
192.168.10.2
192.168.20.2
Subnet
Mask
Protocol
OSPF Inter
OSPF Inter
2/0/11
Local
v1.0, October 2009
State
---------
2/0/11
Full
2/0/19
Full
Next Hop
Intf
---------
2/0/11
2/0/11
192.168.10.2
192.168.10.1
2/0/19
Next Hop
IP Address
---------------
192.168.10.2
192.168.10.0
192.168.20.1
OSPF