NETGEAR FSM7328SNA Administration Manual page 226

NETGEAR Managed Switches Software Administration Manual, Release 8.0
CLI: Setting classofservice Trust Mode
(Netgear Switch) (Config)#classofservice?
dot1p-mapping
ip-dscp-mapping
trust
(Netgear Switch) (Config)#classofservice trust?
dot1p
ip-dscp
(Netgear Switch) (Config)#classofservice trust dot1p?
<cr>
(Netgear Switch) (Config)#classofservice trust dot1p
Web Interface: Setting classofservice Trust Mode
To use the Web interface to show CoS trust mode, proceed as follows:
1. From the main menu, select QoS > Basic >CoS configuration. A screen similar to the following
displays.
Figure 12-2
2. Select the Global radio button.
3. Select the trust dot1p in the Global Trust Mode field.
4. Click the Apply to save the settings.
12-4
Configure dot1p priority mapping.
Maps an IP DSCP value to an internal traffic class.
Sets the Class of Service Trust Mode of an Interface.
Sets the Class of Service Trust Mode of an Interface
to 802.1p.
Sets the Class of Service Trust Mode of an Interface
to IP DSCP.
Press Enter to execute the command.
v1.0, October 2009
Class of Service (CoS) Queuing