NETGEAR FSM7328SNA Administration Manual page 130

NETGEAR Managed Switches Software Administration Manual, Release 8.0
CLI: Configuring Area 1 as a nssa Area
Enable routing on the switch.
(Netgear Switch) #config
(Netgear Switch) (Config)#router ospf
(Netgear Switch) (Config)#ip routing
Configure area 0.0.0.1 as a nssa area.
(Netgear Switch) (Config)#router ospf
(Netgear Switch) (Config-router)#router-id 1.1.1.1
(Netgear Switch) (Config-router)#area 0.0.0.1 nssa
Stop importing summary LSA to the area 0.0.0.1.
(Netgear Switch) (Config-router)#area 0.0.0.1 nssa no-summary
Enable area 0.0.0.1 on the 2/0/19.
(Netgear Switch) (Config-router)#exit
(Netgear Switch) (Config)#interface 2/0/11
(Netgear Switch) (Interface 2/0/11)#routing
(Netgear Switch) (Interface 2/0/11)#ip address 192.168.10.1 255.255.255.0
(Netgear Switch) (Interface 2/0/11)#ip ospf
(Netgear Switch) (Interface 2/0/11)#exit
(Netgear Switch) (Config)#interface 2/0/19
(Netgear Switch) (Interface 2/0/19)#routing
(Netgear Switch) (Interface 2/0/19)#ip address 192.168.20.1 255.255.255.0
(Netgear Switch) (Interface 2/0/19)#ip ospf
(Netgear Switch) (Interface 2/0/19)#ip ospf areaid 0.0.0.1
8-25
v1.0, October 2009
OSPF