NETGEAR FSM7328SNA Administration Manual page 402

NETGEAR Managed Switches Software Administration Manual, Release 8.0
CLI: Configuring a DHCP Reservation
To use the CLI to create a DHCP server with a with a manual pool, enter the following CLI commands:
(Netgear Switch)#config
(Netgear Switch) (Config)#service dhcp
(Netgear Switch) (Config)#ip dhcp pool pool_manual
(Netgear Switch) (Config)#client-name dhcpclient
(Netgear Switch) (Config)#hardware-address 00:01:02:03:04:05
(Netgear Switch) (Config)#host 192.168.200.1 255.255.255.0
(Netgear Switch) (Config)#client-identifier 01:00:01:02:03:04:05
Note: The unique identifier is a concatenation of the media type and MAC addresses. For
example, the Microsoft client identifier for Ethernet address c8:19:24:88:f1:77 is
01:c8:19:24:88:f1:77, where 01 represents the Ethernet media type. For more information,
see the "Address Resolution Protocol Parameters" section of RFC 1700.
Web Interface: Configuring a DHCP Reservation
To use the Web interface to create a DHCP server with a manual pool, proceed as follows:
1. From the main menu, select System > Services > DHCP Server > DHCP Server Configuration. A
screen similar to the following displays.
Figure 22-3
2. Next to Admin Mode, select the Enable radio button.
3. Click Apply to enable the DHCP service.
22-4
v1.0, October 2009
DHCP Server