NETGEAR Managed Switches Software Administration Manual, Release 8.0
a.
From the main menu, select Routing > VLAN > VLAN Routing Wizard. A screen similar to the
following displays.
Figure 7-10
b. Enter the following information in the VLAN Routing Wizard:
•
In the Vlan ID field, enter 20.
•
In the IP Address field, enter 192.150.4.1.
•
In the Network Mask field, enter 255.255.255.0.
c.
Click Unit 1. The ports display.
•
Click the gray box under port 3 once until T displays.
The T specifies that the egress packet is tagged for the port.
d.
Click Apply to save the VLAN that includes ports 3.
3. Enable RIP on the switch ( this step can be skipped since the RIP is enabled by default).
a.
From the main menu, select Routing > RIP > Basic>RIP Configuration. A screen similar to the
following displays.
Figure 7-11
b. Next to the RIP Admin Mode, select Enable radio button.
c.
Click Apply to save the setting.
4. Enable RIP on the VLAN 10 and 20.
7-12
v1.0, October 2009
Routing Information Protocol