NETGEAR Managed Switches Software Administration Manual, Release 8.0
Configure the Switch with a Multicast Router Using VLAN
The example is shown as CLI commands and as a Web interface procedure.
CLI: Configure the Switch with a Multicast Router Using VLAN
This example configures the interface to only forward the snooped IGMP packets that come from VLAN ID
(<VLAN Id>) to the multicast router attached to this interface.
(Netgear Switch)(Interface 1/0/3)# ip igmp mrouter 2
Web Interface: Configuring the Switch with a Multicast Router Using VLAN
To use the Web interface to configure the managed switch, proceed as follows:
1.
From the main menu, select Switching > Multicast > Multicast Router VLAN Configuration. A screen
similar to the following displays.
Figure 14-5
14-6
v1.0, October 2009
IGMP Snooping and Querier