NETGEAR FSM7328SNA Administration Manual page 237

NETGEAR Managed Switches Software Administration Manual, Release 8.0
Attach the defined policy to interfaces 1/0/1 through 1/0/4 in the inbound direction.
(Netgear Switch) (Config)#interface 1/0/1
(Netgear Switch) (Interface 1/0/1)#service-policy in internet_access
(Netgear Switch) (Interface 1/0/1)#exit
(Netgear Switch) (Config)#interface 1/0/2
(Netgear Switch) (Interface 1/0/2)#service-policy in internet_access
(Netgear Switch) (Interface 1/0/2)#exit
(Netgear Switch) (Config)#interface 1/0/3
(Netgear Switch) (Interface 1/0/3)#service-policy in internet_access
(Netgear Switch) (Interface 1/0/3)#exit
(Netgear Switch) (Config)#interface 1/0/4
(Netgear Switch) (Interface 1/0/4)#service-policy in internet_access
(Netgear Switch) (Interface 1/0/4)#exit
Set the CoS queue configuration for the (presumed) egress interface 1/0/5 such that each of queues 1, 2, 3
and 4 get a minimum guaranteed bandwidth of 25%. All queues for this interface use weighted round robin
scheduling by default. The DiffServ inbound policy designates that these queues are to be used for the
departmental traffic through the assign-queue attribute. It is presumed that the switch will forward this
traffic to interface 1/0/5 based on a normal destination address lookup for internet traffic.
(Netgear Switch) (Config)#interface 1/0/5
(Netgear Switch) (Interface 1/0/5)#cos-queue min-bandwidth 0 25 25 25 25 0 0 0
(Netgear Switch) (Interface 1/0/5)#exit
(Netgear Switch) (Config)#exit
Web Interface: DiffServ
To use the Web interface to configure diffserv, proceed as follows:
1. Enable Diffserv.
Differentiated Services
v1.0, October 2009
13-4