NETGEAR Managed Switches Software Administration Manual, Release 8.0
c.
Enter the following information in the IPv6 Interface Configuration:
•
In the IPv6 Prefix edit box, enter 2001::1.
•
In the Length edit box, enter 64.
•
Select Disable in the EUI64 field.
•
Select Disable in the Onlink Flag field.
•
Select Disable in the Autonomous Flag field.
d. Click Add to save the settings.
5.
Enable OSPFv3 on the port 1/0/1.
a.
From the main menu, select Routing > OSPFv3 > Advanced>Interface Configuration. A screen
similar to the following displays.
Figure 8-55
b. Under IP Interface Configuration, scroll down to interface 1/0/1 and select the checkbox for that
interface. Now 1/0/1 appears in the Interface field at the top.
•
In the OSPF Area ID field, enter 0.0.0.0.
•
Select Enable in the Admin Mode field.
c.
Click Apply to save the settings.
6. Display OSPFv3 neighbor.
a.
From the main menu, select Routing > OSPFv3 > Advanced>Neighbor Table. A screen similar to
the following displays.
8-45
v1.0, October 2009
OSPF