NETGEAR FSM7328SNA Administration Manual page 444

NETGEAR Managed Switches Software Administration Manual, Release 8.0
CLI: Configuring PIM-DM
On Switch A
Enable IP routing on the switch.
(Netgear Switch) #configure
(Netgear Switch) (Config)#ip routing
Enable pimdm on the switch.
(Netgear Switch) (Config)#ip pimdm
Enable ip multicast forwarding on the switch.
(Netgear Switch) (Config)#ip multicast
Enable RIP to build unicst IP routing table.
(Netgear Switch) (Config)#interface 1/0/1
(Netgear Switch) (Interface 1/0/1)#routing
(Netgear Switch) (Interface 1/0/1)#ip address
(Netgear Switch) (Interface 1/0/1)#ip rip
Enable PIM-DM on the interface.
(Netgear Switch) (Interface 1/0/1)#ip pimdm
(Netgear Switch) (Interface 1/0/1)#exit
(Netgear Switch) (Config)#interface 1/0/9
(Netgear Switch) (Interface 1/0/9)#routing
(Netgear Switch) (Interface 1/0/9)#ip address
(Netgear Switch) (Interface 1/0/9)#ip rip
(Netgear Switch) (Interface 1/0/9)#ip pimdm
(Netgear Switch) (Interface 1/0/9)#exit
(Netgear Switch) (Config)#interface 1/0/13
(Netgear Switch) (Interface 1/0/13)#routing
(Netgear Switch) (Interface 1/0/13)#ip address
(Netgear Switch) (Interface 1/0/13)#ip rip
(Netgear Switch) (Interface 1/0/13)#ip pimdm
(Netgear Switch) (Interface 1/0/13)#exit
28-3
192.168.2.2
192.168.3.1
192.168.1.2
v1.0, October 2009
255.255.255.0
255.255.255.0
255.255.255.0
PIM