NETGEAR FSM7328SNA Administration Manual page 156

NETGEAR Managed Switches Software Administration Manual, Release 8.0
Enable VRRP on the port.
(Netgear Switch) (Interface 1/0/2)#ip vrrp 20 mode
(Netgear Switch) (Interface 1/0/2)#exit
(Netgear Switch) (Config)#exit
Web Interface: Configuring VRRP on a Master Router
To use the Web interface to configure VRRP on a master router on the switch, proceed as follows:
1. Enable IP routing on the switch:
a. From the main menu, select Routing > IP > IP Configuration. A screen similar to the following
displays.
Figure 10-2
b. Next to the Routing Mode, select the Enable radio button.
c. Click Apply to save the settings.
2. Assign IP address 192.150.2.1 to the port 1/0/2:
a. From the main menu, select Routing > IP > Advanced> IP Interface Configuration. A screen
similar to the following displays.
Figure 10-3
10-3
v1.0, October 2009
Virtual Router Redundancy Protocol