NETGEAR Managed Switches Software Administration Manual, Release 8.0
b. Enter the following information in the Sub Area Configuration.
•
In the Area ID field, enter 0.0.0.1.
•
Select Disable in the Import Summary LSA's field.
c.
Click Add to save the settings.
CLI: Configuring Area 1 as a Stub Area on A2
Enable routing on the switch.
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#router ospf
Set the router id to 2.2.2.2.
(Netgear Switch) (Config-router)#router-id 2.2.2.2
Configure the area 0.0.0.1 as a stub area.
(Netgear Switch) (Config-router)#area 0.0.0.1 stub
Enable OSPF area 0.0.0.1 on the 1/0/15.
(Netgear Switch) (Config-router)#exit
(Netgear Switch) (Config-router)#exit
(Netgear Switch) (Config)#interface 1/0/15
(Netgear Switch) (Interface 1/0/15)#routing
(Netgear Switch) (Interface 1/0/15)#ip address 192.168.20.2
(Netgear Switch) (Interface 1/0/15)#ip ospf
(Netgear Switch) (Interface 1/0/15)#ip ospf areaid 0.0.0.1
(Netgear Switch) (Interface 1/0/15)#exit
(Netgear Switch) (Config)#exit
(Netgear Switch) #show ip route
Total Number of Routes......................... 2
Network
Address
--------------- --------------- ------------
0.0.0.0
0.0.0.0
192.168.20.0
255.255.255.0
8-21
Subnet
Mask
Protocol
OSPF Inter
Local
v1.0, October 2009
255.255.255.0
Next Hop
Next Hop
Intf
IP Address
---------
---------------
1/0/15
192.168.20.1
1/0/15
192.168.20.2
OSPF