NETGEAR Managed Switches Software Administration Manual, Release 8.0
c.
Enter the following information in the IP Interface Configuration.
•
In the IP address, enter 192.168.4.1.
•
In the Subnet Mask, enter 255.255.255.0.
•
Select Enable in the Routing Mode field.
d. Click Apply to save the settings.
5.
Enable rip on the interface 1/0/21.
a.
From the main menu, select Routing >RIP >Advanced > Interface Configuration. A screen similar
to the following displays.
Figure 28-75
b. Select 1/0/21 in the Interface field.
c.
Next to the RIP Admin Mode, select the Enable radio button.
d. Click Apply.
6.
Enable rip on the interface 1/0/22.
a.
From the main menu, select Routing > RIP >Advanced > Interface Configuration. A screen similar
to the following displays.
Figure 28-76
b. Select 1/0/22 in the Interface field.
c.
Next to the RIP Admin Mode, select the Enable radio button.
28-53
v1.0, October 2009
PIM