NETGEAR FSM7328SNA Administration Manual page 298

NETGEAR Managed Switches Software Administration Manual, Release 8.0
Layer 2
RADIUS
Server
Layer 2
Switch
PC 1
Figure 15-12
The following example shows how to authenticate the dot1x users by a RADIUS server. The management
IP address is 10.100.5.33/24. The example is shown as CLI commands and as a Web interface procedure.
CLI: Authenticating dot1x Users by a RADIUS Server
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#interface 1/0/1
(Netgear Switch) (Interface 1/0/1)#routing
(Netgear Switch) (Interface 1/0/1)#ip address 192.168.1.1 255.255.255.0
(Netgear Switch) (Config)#dot1x system-auth-control
Create a username list dot1xList
(Netgear Switch) (Config)#aaa authentication dot1x default radius
Use radius to authenticate the dot1x users.
(Netgear Switch) (Config)#radius server host auth 10.100.5.17
To configure a RADIUS authentication server.
15-14
Switch
v1.0, October 2009
PC 2
Security Management